DeWalt DW007K, Руководство пользователя

Страница: 28 / 116

28
E N G L I S H
• To remove the battery pack, press the release
button (14).
We recommend to insert the battery pack into the
charger directly after removing it from the tool.
Battery cap (fig. B)
A protective cap is supplied to cover the contacts of
a detached battery pack. Without the protective cap
in place, loose metal objects could short circuit the
contacts, causing a fire hazard and damaging the
battery pack.
• Take off the protective cap (18) before placing
the battery pack (15) in the charger or tool.
• Place the protective cap over the contacts
immediately after removing the battery pack from
the charger or tool.
Make sure the protective cap is in place
before storing or carrying a detached
battery pack.
The charger is equipped with an internal fan for rapid
cooling of battery packs. The fan will be automatically
switched on when required. The fan will also be
switched on periodically when there is no battery in
the charger in order to blow dust from the fan vents.
Always wear safety glasses when
plugging in the charger.
Hot/Cold Pack Delay
When the charger detects a battery that is too hot or
too cold, it automatically starts a Hot/Cold Pack
Delay, suspending charging until the battery has
reached an appropriate temperature. The charger
then automatically switches to the pack charging
mode. This feature ensures maximum battery life.
The red indicator blinks long, then short while in the
Hot/Cold Pack Delay mode.
Depth of cut adjustment (fig. A)
• Move the depth adjustment lever (13) up.
• Move the shoe (12) to obtain the correct depth
of cut.
• Move the depth adjustment lever (13) down.
For optimal results, allow the saw blade
to protrude from the workpiece by about
3 mm.
Bevel adjustment (fig. A & C)
The bevel angle can be adjusted between 0° and 45°.
• Loosen the bevel adjustment knob (6).
• Set the bevel angle by tilting the saw shoe (12).
• Tighten the bevel adjustment knob (6).
Shoe adjustment for 90° cuts (fig. C)
• Adjust the saw to 0° bevel.
• Retract the blade guard using the lever (11) and
place the saw on the blade side.
• Loosen the bevel adjustment knob (6).
• Place a square against the blade and shoe to
check the 90° setting.
Replacing the saw blade (fig. D)
• Engage the blade lock button (4) and unscrew
the blade camping screw (9) by turning clockwise
using the Allen key supplied with the tool.
• Retract the lower blade guard using the lever (11)
and replace the blade (21). Reinstall the washers
(20 & 22) in the correct position.
• Check the direction of rotation of the blade.
• Thread on the blade clamping screw (9) by hand to
hold the washer in position. Turn counterclockwise.
• Press the blade lock button (4) while turning the
spindle until the blade stops rotating.
• Tighten the blade clamping screw firmly using the
Allen key.
Adjusting the riving knife (fig. D)
For the correct adjustment of the riving knife (8),
refer to the inset in figure C. Adjust the clearance of
the riving knife after changing the saw blade or
whenever necessary.
• Loosen the screw (23) and pull out the riving
knife to its maximum length.
• Adjust the clearance and tighten the screw.
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Ensure the material to be sawn is firmly
secured in place.