9
Trigger Switch (Fig. 3)
WARNING:
This tool has no provision to lock the trigger switch in the ON position
and should never be locked ON by any other means.
Release the trigger switch lock-off button (A) by pressing the button as shown (Fig. 3).
Pull the trigger switch (B) to turn the motor on. Releasing the trigger switch turns the
motor off.
FIG. 3
B
A
Changing Blades (Fig. 4, 5)
TO INSTALL THE BLADE (FIG. 4, 5)
1. Place inner clamp washer (O) on saw spindle with the large flat surface facing
out toward the blade (Fig. 4a, 4b).
2. Retract the lower blade guard (G) and place blade on saw spindle against the
inner clamp washer, making sure that the blade will rotate in the proper direction
(the direction of the rotation arrow on the saw blade and the teeth must point in
the same direction as the direction of rotation arrow on the lower blade guard).
Do not assume that the printing on the blade will always be facing you when
properly installed. When retracting the lower blade guard to install the blade,
check the condition and operation of the lower blade guard to assure that it is
working properly. Make sure it moves freely and does not touch the blade or any
other part, in all angles and depths of cut.
FIG. 4a
O
K
L
F
P
H
G
3. Place outer clamp washer (P) on saw spindle with the large flat surface against the
blade with beveled side facing out.
4. Thread blade clamping screw (H) into saw spindle by hand (screw has left-hand
threads and must be turned counterclockwise to tighten).
5. Depress the blade lock button (K) while turning the saw spindle with the blade
wrench (N) until the blade lock engages and the blade stops rotating (Fig. 5).
6. Tighten the blade clamping screw firmly with the blade wrench.
Содержание DCS391-XE
Страница 1: ...DCS391 XE DCS393 XE 18 V CORDLESS 165 mm 6 1 2 CIRCULAR SAW INSTRUCTION MANUAL ...
Страница 18: ......
Страница 19: ......