•
crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do
this type of work. To reduce your exposure to these chemicals: work
in a well ventilated area, and work with approved safety equipment,
such as those dust masks that are specially designed to fi lter out
microscopic particles.
•
Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with soap
and water.
Allowing dust to get into your mouth, eyes, or lay on
the skin may promote absorption of harmful chemicals.
WARNING:
Use of this tool can generate and/or disperse dust,
which may cause serious and permanent respiratory or other injury.
Always use NIOSH/OSHA approved respiratory protection appropriate
for the dust exposure. Direct particles away from face and body.
WARNING: Always wear proper personal hearing protection
that conforms to ANSI S12.6 (S3.19) during use.
Under some
conditions and duration of use, noise from this product may contribute
to hearing loss.
CAUTION: When not in use, place tool on its side on a stable
surface where it will not cause a tripping or falling hazard.
Some tools with large battery packs will stand upright on the battery
pack but may be easily knocked over.
• The label on your tool may include the following symbols. The
symbols and their defi nitions are as follows:
V ................... volts
A ...................... amperes
Hz ................. hertz
W ..................... watts
min ............... minutes
or AC .......... alternating
or DC ... direct current
current
................. Class I Construction
or AC/DC ... alternating
..................... (grounded)
........................
or direct
................. Class II Construction
current
(double insulated)
no .................... no load
…/min ........... per minute
speed
BPM ............. beats per minute n
...................... rated
IPM ............... impacts per minute
........................
speed
RPM ............. revolutions per
.................... earthing
minute terminal
sfpm ............. surface feet
..................... safety alert
.....................
per minute
symbol
SPM .............strokes per minute
psi .................... pounds per
.....................
........................
square inch
Important Safety Instructions for All
Battery Packs
When ordering replacement battery packs, be sure to include catalog
number and voltage. Consult the chart at the end of this manual for
compatibility of chargers and battery packs.
The battery pack is not fully charged out of the carton. Before using
the battery pack and charger, read the safety instructions below. Then
follow charging procedures outlined.
READ ALL INSTRUCTIONS
•
Do not charge or use battery in explosive atmospheres,
such as in the presence of fl ammable liquids, gases or dust.
Inserting or removing the battery from the charger may ignite the
dust or fumes.
• NEVER force battery pack into charger. DO NOT modify
battery pack in any way to fi t into a non-compatible charger
English
4
Содержание DCGG570
Страница 2: ......
