26
English
Safety Warnings and Instructions: Drilling
WARNING:
Tool may stall (if overloaded or improperly used)
causing a twist. Always expect the stall. Grip the drill firmly to control
the twisting action and prevent loss of control which could cause
personal injury. If a stall does occur, release the trigger immediately
and determine the reason for the stall before restarting.
•
Hold tool firmly to control its twisting action.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
DESCRIPTION (FIG. 2)
WARNING:
Never modify the power tool or any part of it. Damage
or personal injury could result.
FIG. 2
A
C
B
D
E
F
G
A. Quick release collar
B. Torque control collar
C. LED Light
D. Two speed switch
E. Forward / reverse switch
F. Release button
G. Charging port
OPERATION
WARNING:
Always observe the safety instructions and applicable
regulations.
Inserting an Accessory (Fig. 2, 3)
1. Hold the screwdriver upright as shown in
FIG. 3
A
Figure 3 and pull down on the quick
release collar (A).
2. Insert a hex shank accessory into the
holder.
3.
Release the quick release collar.
NOTE
: If bit does not fit into spindle,
rotate the bit and reinsert it.
Removing an Accessory
(Fig. 2, 3)
1. Hold the screwdriver upright as shown in Figure 3 and pull down
on the quick release collar (A).
2. Pull accessory straight out.
Switch (Fig. 2)
To turn the tool ON in a forward direction, press the top section of
the rocker switch (E) and the tool will run. Release pressure from the
switch and the tool will stop.
To operate in reverse, press the bottom section of the rocker switch.
Without depressing the rocker switch the tool is locked and will act
as any conventional, non-powered screwdriver.
Содержание DCF060
Страница 2: ......
