DeWalt DCD937-XE, Инструкция по эксплуатации

Страница: 12 / 16

10
Your tool features a keyless chuck with one rotating sleeve for one-handed operation
of the chuck. To insert a drill bit or other accessory, follow these steps.
1. Turn off tool and disconnect tool from power source.
2. Grasp the black sleeve of the chuck (D) with one hand and use the other hand
to secure the tool as shown in Figure 6. Rotate the sleeve counterclockwise (as
viewed from the front) far enough to accept the desired accessory.
3. Insert the accessory about 19 mm (3/4") into the chuck (Fig. 7). Tighten securely
by rotating the chuck sleeve clockwise with one hand while holding the tool with
the other hand (Fig. 8). Continue to rotate the chuck sleeve until several ratchet
clicks are heard to ensure full gripping power.
To release the accessory, repeat Steps 1 and 2 above.
Be sure to tighten chuck with one hand on the chuck sleeve and one hand holding the
tool for maximum tightness.
FIG. 7 FIG. 8
D
FIG. 6
Belt Hook and Magnetic Bit Holder (Fig. 2)
WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect battery pack before making any adjustments or removing/installing
attachments or accessories .
WARNING: To reduce the risk of serious personal injury, DO NOT suspend tool
overhead or suspend objects from the belt hook. ONLY hang tool’s belt hook from a
work belt.
WARNING: To reduce the risk of serious personal injury, ensure the screw
holding the belt hook is secure.
IMPORTANT: When attaching or replacing the belt hook or magnetic bit holder, use
only the screw (L) that is provided. Be sure to securely tighten the screw.
The belt hook (J) and magnetic bit holder (K) can be be attached to either side of the
tool using only the screw (L) provided, to accommodate left- or right- handed users.
If the hook or magnetic bit holder is not desired at all, it can be removed from the tool.
To move belt hook or magnetic bit holder, remove the screw (L) that holds it in place
then reassemble on the opposite side. Be sure to securely tighten the screw.
OPERATION
WARNING: To reduce the risk of serious personal injury, turn the tool off and
disconnect the battery pack before making any adjustments or removing/installing
attachments or accessories. An accidental start-up can cause injury.
Installing and Removing the Battery Pack (Fig. 9)
NOTE: For best results, make sure your battery pack is fully charged.
FIG. 9
I
To install the battery pack into the tool handle, align the battery pack with the rails
inside the tool’s handle and slide it into the handle until the battery pack is firmly
seated in the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release button (I) and firmly pull
the battery pack out of the tool handle. Insert it into the charger as described in the
charger section of this manual.