11
1. Open the guard latch (L), and align the lugs (M) on the
M
L
N
guard with the slots (N) on the gear case.
2. Push the guard down until the guard lugs engage
and rotate freely in the groove on the gear case hub.
3. With the guard latch open, rotate the guard (H) into
the desired working position. The guard body should
be positioned between the spindle and the operator to
provide maximum operator protection.
4. Close the guard latch to secure the guard on the
gear case. You should not be able to rotate the
H
guard by hand when the latch is closed. Do not
operate the grinder with a loose guard or the
clamp lever in open position.
5. To remove the guard, open the guard latch,
rotate the guard so that the lugs are aligned
with the slots and pull up on the guard.
NOTE:
The guard is pre-adjusted to the diameter of
the gear case hub at the factory. If, after a period of
O
time, the guard becomes loose, tighten the
adjusting screw (O) with clamp lever in the closed
position with guard installed on the tool.
CAUTION:
If the guard cannot be tightened by the
adjusting clamp, do not use the tool. To reduce the
risk of personal injury, take the tool and guard to a
service center to repair or replace the guard.
CAUTION:
To reduce the risk of damage to the
tool, do not tighten the adjusting screw with the clamp lever in the open position.
Undetectable damage to the guard or the mounting hub may result.
NOTE
: Edge grinding and cutting can be performed with Type 27 wheels designed
and specified for this purpose; 6.35 mm (1/4") thick wheels are designed for surface
grinding while 3.17 mm (1/8") wheels are designed for edge grinding. Cutting can
also be performed by using a Type 1 wheel and a Type 1 guard.
OPERATION
Switch
LOCK-OFF BUTTON AND TRIGGER SWITCH
LOCKED
UNLOCKED
B
A
Your cut-off tool is equipped with a lock-off
button (B).
To lock the trigger switch,
press the lock-off
button as shown. When the lock-off button
is depressed to the lock icon, the unit is
locked.
Always lock the trigger switch when carrying
or storing the tool to eliminate unintentional
starting.
To unlock the trigger switch,
press the
lock-off button. When the lock-off button is
depressed to the unlock icon, the unit is unlocked. The lock-off button is colored
red
to indicate when the switch is in its
unlocked
position.
Pull the trigger switch (A) to turn the tool ON. Releasing the trigger switch turns the
tool OFF.
NOTE:
This tool has no provision to lock the switch in the ON position, and should
never be locked ON by any other means.
CAUTION:
Hold the side handle and body of the tool firmly to maintain control of
the tool at start up and during use and until the wheel or accessory stops rotating.
Make sure the wheel has come to a complete stop be fore laying the tool down.
CAUTION:
Allow the tool to reach full speed before touching tool to the work
surface. Lift the tool from the work surface before turning the tool off.
SPINDLE LOCK
The spindle lock pin is provided to prevent the spindle from rotating when installing
or removing wheels. Operate the spindle lock pin only when the tool is turned off, the
battery is removed, and the wheel has come to a complete stop.
CAUTION:
To reduce the risk of damage to the tool, do not engage the spindle lock
while the tool is operating. Damage to the tool will result and attached accessory may
spin off possibly resulting in injury.
Содержание DC415-XE
Страница 1: ...DC415 XE HEAVY DUTY 36V CORDLESS FINISHING GRINDER INSTRUCTION MANUAL ...
Страница 2: ......
