DeWalt D28715-XE, Инструкция по эксплуатации

Страница: 9 / 12

9
FIG. 6
Removal and Installation of Wheels (Fig. 1, 7)
The Quick-Change blade clamp requires no tools to change the blade.
1. Push in wheel lock lever (L) and rotate
FIG. 7
Q
U
J
S
O
U
P
J
S
wheel (J) by hand until wheel lock
lever engages slot in inside flange (S)
to lock wheel. Loosen the Quick-
Change blade clamp (Q)
counterclockwise. Clamp has right-
hand thread.
2. Remove the Quick-Change blade
clamp (Q), blade clamp washer (U)
and old wheel (J) by hand.
3. Make sure flange surfaces are clean
and flat. Install the new abrasive wheel
by reversing the above steps.
4. Tighten the Quick-Change blade clamp
clockwise until the knob clicks as least
three times to ensure the knob is tight.
The Quick-Change blade clamp cannot
be overtightened.
FOR A MORE ACCURATE SQUARE CUT
1. Unlock the fence.
2. Push the arm down until the wheel extends into the base.
3. Place a square against the wheel and adjust the fence against the square.
4. Lock the fence into position.
ANGLE ADJUSTMENT
INDICATOR
SLOT EDGE
WHEEL
SQUARE
FIG. 5
OPERATION
WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories. An accidental start-up can cause injury.
Usage (Fig. 1, 6)
Refer to Figure 6 for proper body positioning during use.
To start the tool, depress the trigger switch (M). To turn the tool off, release the trigger
switch. Keep hands and material from wheel until it has coasted to a stop.
To prevent unauthorized use of tool, install a standard padlock (not included) into the
padlock hole (N) located in the trigger.