DeWalt D26411-XE, Инструкция по эксплуатации

Страница: 10 / 12

8
NOTE: To reduce the cooling time, switch the tool on at the lowest air temperature
setting and let it run for a few minutes before turning the heat gun off.
MAINTENANCE
WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect battery pack before making any adjustments or removing/installing
attachments or accessories.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air at least once
a week. To minimize the risk of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.
WARNING: Never use solvents or other harsh chemicals for cleaning the
non-metallic parts of the tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with water and mild soap. Never let
any liquid get inside the tool; never immerse any part of the tool into a liquid.
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should be performed by certified
service centers or other qualified service organizations, always using identical
replacement parts.
ACCESSORIES
WARNING: Since accessories, other than those offered by D
E
WALT, have not been
tested with this product, use of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
E
WALT, recommended accessories should be used
with this product.
Recommended accessories for use with your tool are available at extra cost from
your local service center. If you need any assistance in locating any accessory,
please contact D
E
WALT Industrial Tool Co., 20 Fletcher Road, Mooroolbark, VIC 3138
Australia or call 1800 654 155 or (NZ) 0800 339258.
4. Direct the hot air onto the paint to be removed.
Best results will be achieved if the heat gun is moved slowly, but CONSTANTLY,
from side to side to evenly distribute heat. DO NOT LINGER OR PAUSE IN ONE
SPOT.
5. When the paint softens, scrape the paint away using a hand scraper.
REMEMBER: Splinters and small particles of stripped paint can be ignited and blown
through holes and cracks in the surface being stripped.
Stationary Use (Fig. 1)
This tool can also be used in stationary mode.
1. Fold down the kickstand (C) as shown in Figure 1.
2. Set the tool onto a level, stable workbench. Ensure the tool will not tip over.
3. Secure the power cord to prevent entanglement or pulling the tool off the
workbench.
4. Turn the tool on by selecting the desired air flow.
Constant Heat Control (Overload Protection)
When the tool is overloaded, this feature protects the heating element from damage
without stopping the tool and/or without a cool down period.
1. When the temperature gets too hot, the heating element switches itself off. The
motor will continue to run and produce cold air.
2. When the temperature has cooled sufficiently (taking only a few seconds) the
heating element will switch on automatically.
Tool Ring (Fig. 1)
WARNING: ALWAYS turn heat gun off, disconnect from the power source and let
the tool cool down for at least 30 minutes before moving or storing it.
For easy storage, the tool can hang from the tool ring (F). The heat gun should be
stored indoors.
Cool Down Period
The nozzle and accessory becomes very hot during use. Turn heat gun off, disconnect
from the power source and let the tool cool down for at least 30 minutes before
moving or storing it.