DeWalt D215821, Руководство пользователя

Страница: 22 / 80

22
E N G L I S H
Assembly and adjustment
+
Also refer to your drill manual.
Mounting the drill (fig. B)
● Remove the side handle from the machine.
● Loosen the screws (31) using an Allen key.
● Mount the machine to the stand.
● Tighten the screws (31).
@
Always mount your drill firmly to prevent
movement.
Installing the stand (fig. C - F)
The stand can be installed either vertically (fig. C)
or horizontally (fig. D) on a surface such as a floor
or a wall.
@
Always make sure the stand is securely
fastened on the surface.
Mounting the stand with the fastening set
(fig. E1 & E2)
A fastening set is required to secure the stand to
masonry (fig. E1) or concrete (fig. E2) surfaces.
● Locate the stand at the desired position and mark
the location of the mounting hole on the wall.
● Drill a hole at the marked location.
- In concrete: 15 mm diameter by 55 mm deep
- In masonry: 20 mm diameter by 85 mm deep
● Insert the anchor plug (32) into the hole.
● Tighten the anchor (33) into the anchor plug.
● Position the stand over the anchor.
● Place a washer (34) and wingnut (35) onto the
bolt. Securely tighten the wingnut.
Mounting the stand with the bracing bracket
(fig. F)
For a quick set up in indoor applications, a bracing
bracket can be used to secure the stand.
● Position the stand.
● Place the bracket foot (36) against the base (9).
● Move the latch (37) out of the way to depress
the lever (38). Extend the bracket (22) until it
reaches the opposite surface. Release the lever.
● Clamp the bracket in position using the rod (39).
● Insert the pin (40) into the hole closest to the
clamping mechanism.
Adjusting the stand (fig. A)
● Read one of the air levels to check whether the
stand is level.
- Air level (7) for vertical applications
- Air level (8) for horizontal applications
● If adjustment is required, proceed as follows:
● Turn the stabilizer bolts (11) one by one until
the stand is level
Mounting the water collection ring (fig. H)
If the stand is used in wet drilling applications,
a water collection ring can be mounted to ensure a
proper discharge of water.
● Loosen the nut on one of the bolts (11) a few
turns.
● Hold the water collection ring (23) in front of the
base (6).
● Slide the recessed end of the mounting bracket
(41) in the space created between the nut and
the base.
● Check that the assembly aligns with the
accessory fitted.
● Securely tighten the nut.
Fitting the feed handle (fig. J)
The quick-release feed handle (3) can be mounted
in one simple operation both to the left and the
right of the stand.
● Align the locating rod in the feed handle with
the slot in the shaft (42).
● Push the handle onto the shaft.
Adjusting the friction (fig. A)
The friction knob (9) is used to increase or
decrease the friction of the carriage mechanism.
● Turn the knob clockwise to increase the friction.
● Turn the knob counterclockwise to decrease the
friction.
Instructions for use
@
Always observe the safety instructions
and applicable regulations.
+
Also refer to your drill manual.
Prior to operation:
● Make sure the stand is fastened securely.