Devolo dLAN Highspeed Ethernet, Руководство пользователя

Страница: 9 / 25

|
Connection and startup
9
|
devolo dLAN Highspeed Ethernet
|
10/Act
: Is lit whenever an Ethernet connection exists; flashes to signal
10 Mbps data rate.
Col : Flashes at a faster rate if the network is experiencing increasing
use.
dLAN
Power : Is lit when the dLAN HS Ethernet is ready for operation.
Act: Flashes when data are being sent or received over the power lines.
Link : Is lit if connected to the dLAN network.
Ethernet connection : This is the connection point on the dLAN HS Ether-
net for connecting it to a computer or another device with the network cable
(included).
Make sure that all of the dLAN adapter that you want to add to your network
are also connected to the power supply grid. After about 15 minutes, a dLAN
adapter switches into stand-by mode unless there is an active device connected
to the Ethernet interface. dLAN adapters in stand-by mode are not accessible
over the power supply grid.
2.3 Connecting the
dLAN HS Ethernet
In this section, we will show you how to connect the dLAN HS Ethernet to a com-
puter.
Before connecting the dLAN HS Ethernet, note its security ID and keep it ready
for configuring the network. You can find the security ID on the bottom of the
dLAN adapter.
햲
With the computer running connect the dLAN HS Ethernet to an Ethernet
port of the computer with the network cable (included).
햳
Plug the dLAN HS Ethernet adapter into a convenient power socket.
햴
Continue with the installation of the devolo dLAN software. For more infor-
mation, refer to the chapter on 'devolo dLAN software'.
No drivers are required for running the dLAN HS Ethernet.