Devolo dLAN 1200+ WiFi ac, Руководство пользователя

Страница: 17 / 48

17 Introduction
devolo dLAN 1200+ WiFi ac
* Information about the web interface can be
found in Chapter
4 Network configuration .
** Information on improving the transmission rate
can be found in Chapter
5.3 Bandwidth optimi-
zation .
***A dLAN adapter switches to standby mode
after approximately 10 minutes if no active
network device (e.g. computer) is connected to the
network interface and the Wi-Fi is switched off. In
this mode, the dLAN adapter cannot be accessed
over the electrical wiring. As soon as the network
device (e.g. computer) connected to the network
interface is switched on again, your dLAN adapter
can also be accessed over the electrical wiring
again.
Check whether the adapter is connected to
the mains supply correctly and whether the
pairing operation has been carried out suc-
cessfully. For more information about this,
refer to
3.3 Connecting the
dLAN 1200+ WiFi ac
2.4.2Wi-Fi button
The Wi-Fi button controls the following Wi-
Fi functions:
Wi-Fi On/Off:
b
In the factory default settings , the Wi-Fi set-
ting is already enabled and the Wi-Fi encryp-
tion is set to WPA2 . The WiFi key is the unique
key of the dLAN 1200+ WiFi ac. You can find
this key on the label on the rear side of the
housing.
b
In order to switch Wi-Fi off , press and hold the
Wi-Fi button longer than 3 seconds .
b
In order to switch Wi-Fi back on , tap the Wi-Fi
button .
Connecting Wi-Fi devices via WPS
b
If the device is still on factory defaults , tap the
Wi-Fi button in order to activate WPS .
b
If the Wi-Fi connection was switched off and
you would like to activate WPS , press the Wi-
Fig. 3 Wi-Fi button