Setting the Time
When the heater is switched on press set and the MO light will illuminate
to indicate that the current day is Monday. Press the set button repeatedly
until you find the actual day you want to set the time for (the first two letters
of the 7 days of the week will illuminate to indicate what day you are
currently on, i.e. Su=Sunday). When the correct day is illuminated press
the set button and the hours LED display will blink 00, use the
– and +
button to set the hour from 1-24 hours (01= 1am and 00=12am Midnight).
Then press set and the minute LED display will blink 00, use the
– and +
button to set the minute from 00-59 minutes (01= 1 minute and 59= 59
minutes). Finally press the set button for a further time to confirm current
the time.
Note:
After initially pressing the set button you must select the day of the
week within 5 seconds, otherwise the heater will revert to its normal
operating function. When the time is set, it will remain on the appliance
until the heater is switched off.
GENERAL OPERATION
The heater operates in three modes: Cold, Warm and Hot.
▪
Cold Mode (Fan)
▪
Warm Mode (1000W Output = I/W)
▪
Hot Mode (2000W Output = II/W)
To cycle between the three modes, press the Mode button on the remote
control. Cold mode does not have a display light, the warm and hot mode
display lights are as above (they will illuminate when in operation).
When the heater is switched on the units default setting is to blow cold air
(operate in cold mode).
24-hour Timer Function
The 24-hour timer function is used to select a time within the next 24 hours
for the heater to shutdown (01= 1 hour until shutdown, 24= 24 hours until
shutdown. This function can be used in any of the operating modes. If a
timer is set from 1-24 hours the day timer display light will illuminate. The
timer can be set by pressing the set button when you reach the desired
hour or waiting 3 seconds whilst the desired hour is flashing for it to
automatically set.
Note:
If the day timer display light is not on then no timer is currently set
(i.e. the timer is 00). You can only set shutdown times by the hour, not
minutes.
Thermostat Instructions
You can adjust the temperature by pressing the
– or + button on the remote
control, whilst in any of the three modes. The temperature range can be
set between 10
℃
to 49
℃
.
When the ambient temperature falls 2 degrees below the set temperature,
the heater will begin to operate in warm mode.
When the ambient temperature falls 4 degrees below the set temperature,
the heater will begin to operate in hot mode.
When the ambient temperature is 1 degree or
≧
than the set temperature,
the heater will blow out cold air.
Weekly Timer Function
The weekly timer function allows you to set a startup and shut down time
for each day of the week. This function can be used in all three modes and
can only be set up via the remote control.
P6 (press the
– and + button at the same time) = Weekly timer set up mode
W.T= W.Timer button (Weekly Timer Button)
Press P6 to enter the weekly timer set up mode.
Weekday- Press the W.T button and the MO display light will illuminate to
indicate that you are on Monday, alternatively press the + or
– button to
cycle between the 7 days. The ON display light will also illuminate to
indicate that you are setting a time for the heater to begin operating.
Start Up Hour- When you find the desired day press the W.T button to set
the hour that you want the heater to begin operating on your chosen day
from 01 to 00 (01=1am and 00=12am Midnight). Use the + and
– buttons
to set the start-up hour. The hour display will blink 00 before a start-up time