Plug the power supply cable into the provided connector-chassis at the rear of the unit. Check the
power supply you wish to plug the unit into, to make sure the outlet has a proper voltage. Do not turn
the power on or connect any cable if you suspect that the voltage is incorrect, or if the cable shows
defects.
Connecting signal cables
The unit has several professional audio connectors at the rear side of the unit. For both channels there
is a separate balanced XLR output. There also is a MIX output with unbalanced 6.35mm jack (for use
at simple setups). You can not use both outputs (XLR and 6.35mm jack) at the same time. We advise
to use the XLR outputs as much as possible, as this provides a better signal transportation with a
minimum chance of error. A unbalanced 6.35mm jack cable is included.
Setting up the receiver
As shown in the illustration above, the information of both microphones is bundled on 1 display. Each
microphone shows information on the display, regarding the Frequency and the Channel.
To change the selected frequency, press SET, then use the UP and DOWN buttons to adjust the
frequency. Press ESC to exit the menu and save the settings, press IR to match the frequency with
your microphone (by synchronizing, as shown before in this manual).
It is also possible to take over the frequency that you already selected on your microphone. Hold down
the DOWN-button and let the receiver match the frequency automatically.
Lock and unlock the receiver
Hold ESC, after a while the display shows ‘LOCK’. Hold ESC again for a while and the ‘LOCK’ item on
the display will disappear.
Volume settings
Use the VOLUME buttons to adjust the sound of the microphones. Use the LED VU-meters next to the
display to choose the right volume setting.
