Synchronizing the microphones, selecting the right frequencies
When you have set up the receiver and turned it on, synchronize the wireless microphones with the
receiver using the infrared synchronizing system.
To do this, point the infrared sensor of the microphone to the infrared sensor on the unit, while you
hold the microphone in front of the unit.
When you are on stage and need to change frequencies in a hurry, you can also unscrew the bottom
cap of the handheld microphones and hold the UP button for a few seconds. This way, the buttons will
be unlocked. When the buttons are already unlocked, continue to the next step.
Use the UP and DOWN buttons to select the right frequency, use the SET button to confirm and save
the selected frequency.
Distance adjustment
Sometimes, other electronical devices might interrupt your performance as you are performing on
stage. When these disturbing devices are relatively far away, you can decrease the distance setting to
avoid interference at the receiver.
Use the H and L buttons to adjust the distance (by decreasing the signal power). H stands for far
distance, L stands for short distance. You will see on the main display that the RF signal indicator
changes.
Volume adjustment
When you want to change the volume sensitivity on your microphone, press SET on the microphone
(after you removed the cover at the bottom). The display will show ‘VOL’ which means you are able to
change the volume, using the UP and DOWN buttons. After 3 seconds of inactivity, the unit will return
to the frequency display, so you can test the new settings.
Backlight adjustment
When you want to change the backlight of the display (as this might draw too much attention on dark
stages), hold the SET butt
on for about two seconds. The display will show ‘LED’ on the display. Use
the UP/DOWN buttons to increase or decrease the brightness of the display, it is also possible to turn
the backlight completely off. When no activity is detected, the display will turn back to the main display,
with the settings saved.
Setting up the receiver
Install the receiver on a solid surface, or in a 19 inch flightcase or rack. Use the two included antennas
and screw them onto the device at the provided mounting points.
Place the antennas in a V-shape, to create the best signal receiving environment for the antennas.
The best set-up of the antennas would be in a 90 degree angle, compared to each other.
