16- ENG
A16091
ENGINE
Consult the Engine Owners Manual for
the manufacturer's recommendations
for storage.
PUMP
The manufacturer recommends using
a pump protector/winterizer, such as
DP80, when storing the unit for more
than 30 days and/or when freezing
temperatures are expected. If a pump
protector/winterizer is not available,
RV antifreeze or windshield washer
fluid needs to be run through the
pump as outlined in the steps below.
NOTE:
Using a pump protector/
winterizer, RV antifreeze or windshield
washer fluid is to provide proper
lubrication to the internal seals of the
pump regardless of temperature or
environment.
1.
Obtain a funnel, 6 oz. of RV
antifreeze or windshield washer
fluid, and 16–36" of garden hose
with a male hose connector
attached to one end.
Risk of property
damage. Use only
RV antifreeze. Any other an ti freeze is
corrosive and can damage pump.
2.
Disconnect spark plug wire.
3. Connect length of garden hose
to water inlet of pump.
4.
Add RV antifreeze
or windshield
washer fluid to hose as shown.
5. Pull engine starter rope slowly
several times until antifreeze/
washer fluid comes out of high-
pressure hose con nec tion of
pump.
6. Remove garden hose
from water
inlet of pump.
7. Reconnect spark plug wire
.
PRESSURE WASHER
1.
Drain all water from high pressure
hose, coil it, and store it in cradle
of the pressure washer handle.
2.
Drain all water from spray gun
and wand by holding spray gun
in a vertical position with nozzle
end pointing down and squeezing
trigger. Store in gun holder.
3.
Store chemical hose so it is
protected from dam age.
4.
If space is needed, remove
handles and replace as shown.
STORAGE
