Instruction Booklet
SEREN
6
JOYSTICK
：
•
Self Diagnostic Warning Lights
Flashing of lights indicates there is a problem within power chair. See page 19 for more
information.
•
Battery Gauge
There are eleven LED lights on joystick. When all LED lights are on, batteries are
fully charged; The Battery Gauge is used to indicate power on and provides an estimate
of the remaining battery capacity.
Any green LEDs lit indicate well charged batteries.
If only amber and red LEDs are lit, the batteries are moderately charged. Recharge
before undertaking a long trip.
If only red LEDs are lit, the batteries are running out of charge. Recharge as soon as
possible.
•
Extendable Bracket
By releasing Knob (B) the joystick bracket (C) is able to extend and retract. With joystick
retracted, this enables you to pull up to any table, and tighten knob (B), when adjusted
to a comfortasle position.
•
While the power is ON, press and hold the Power button for 4 seconds.
•
The display will turn off immediately.
•
After 4 seconds all LED's will flash briefly and the horn will sound a short beep.
•
The powerchair will then turn off.
•
While SHARK is locked, press the button to turn SHARK on.
•
All LED's will flash briefly. The Battery Gauge LED's will then perform a slow right-to-left
chase.
•
Press the Horn button twice before the countdown is competed (approximately 10 seconds).
•
The current state-of-charge will then be displayed and SHARK may be operated normally.
To LOCK SHARK
To UNLOCK SHARK
Figure 4
Figure 5
(A)
(C)
(B)
If the user does not press the Horn button twice before the countdown is
complete, the Horn will sound a short beep and SHARK will turn itself off.
The unlock sequence must be completed successfully before SHARK will
drive again.
Issue 2
