Ind.
Ref No. Replacement
Parts
Part No.
Description
Req.
1
HAF-404
Filter Change Indicator
1
(not shown)
1A
Body
1
2
O-Ring
1
3
HAF-36
Filter and O-Ring Kit
1
4
HAF-11
Manual Drain
1
5
HAF-8
Plastic Bowl
1
6
HAF-19
Metal Bowl Guard
1
7
HAF-409
Clamp Ring
1
SERVICE BULLETIN
SB-6-155-B
Replaces SB-6-155-A
7
3
2
1A
4
HAF-517 - 75 CFM CHARCOAL FILTER
6
5
1 (not shown)
Figure 1 - HAF-517, 75 CFM Charcoal Filter
SPECIFICATIONS
Air Filter:
Air Inlet
1/2" NPT(F)
Air Outlet
1/2" NPT(F)
Air Flow Capacity
75 CFM @ 100 PSI
Maximum Inlet Pressure
150 PSIG (10.3 Bar)
Maximum Operating Pressure
150 PSIG (10.3 Bar)
Maximum Temperature
150° F (65.6°C)
Aerosol Filter
0.003 ppm/wt.
Particulate Filter
3.0 micron
PARTS LIST
IMPORTANT: Read and follow all INSTRUCTIONS and
SAFETY PRECAUTIONS before installing, operating
or maintaining this equipment. Keep this manual for
future reference.
Risk of explosion or fire.
Improper use can cause personal injury.
• This product is designed and intended for
use in industrial compressed air systems only.
Do not use for liquids or gasses other than air.
• Do not use where pressure or temperature
can exceed rated operating conditions (see
specifications).
• Regulated outlet pressure must never be
set higher than the maximum operating
pressure of the downstream air tool or
equipment. An outlet pressure gauge should
always be used.
Risk of injury. Do not place unit in service
without metal bowl guard installed. Filter
units are sold only with metal bowl guards.
To minimize the danger of flying fragments
in the event of plastic bowl failure, guard
must not be removed. If the unit is in ser-
vice without the metal bowl guard installed,
manufacturer’s warranties are void and the
manufacturer assumes no responsibility for
any resulting loss. If unit has been in service
and does not have a metal bowl guard, order
one and install before placing back in service.
Certain compressor oils, cleaning agents and
solvents may attack the plastic and rubber
components used in the construction of this
product. This product should not be used in
conjunciton with or in the vicinity of these
materials. Read and follow material labels
carefully. Please consult DeVilbiss if in doubt.
