10 - Eng
D24156
READ THIS MANUAL AND UNDERSTAND ALL SAFETY WARNINGS AND
INSTRUCTIONS BEFORE OPERATING TOOL.
OPERATING THE TOOL
1.
Add
one drop
of DeVilbiss Air Tool Oil (supplied) into the air inlet. High
speed spindle oil, such as Unocal RX22, or 3-in1 oil can be used.
Keep out of the reach of children. If taken internally, do not
induce vomiting, call a doctor immediately or contact your local
poison control center.
2.
Connect the Tool to the air supply.
3.
Regulate the air pressure to obtain a minimum of 75 PSI at the tool.
4.
Set air pressure regulator to 75 PSI and test for proper fastener penetration
by driving fasteners into a sample piece of wood. If the fasteners do not
achieve the desired penetration, adjust the air pressure to a lower or higher
setting until the desired penetration is achieved. Do not exceed the
maximum operating PSI at the tool.
NOTE
;
Check and replace any damaged or worn components on the tool. The
safety warning labels on the tool must also be replaced if they are not legible.
Protect your eyes and ears. Wear Z87.1 safety glasses with side
shields. Wear hearing protection. Employers and users are re-
sponsible for ensuring the user or anyone near the tool uses the prescribed
safety equipment.
3.
Insert a stick of fasteners into the magazine. Make sure fasteners are not
dirty or damaged. Use DeVilbiss fasteners or equivalent for proper fastener
performance.
NOTE:
On brad nailer make sure the pointed ends of the fasteners are loaded
with the points downward.
4.
Slide magazine until it locks in place.
Stapler
Brad Nailer
