DeVilbiss AGF-508, Руководство по эксплуатации

Страница: 5 / 8

© ITW LTD 1994 – SB-E-2-782 5
CHART 1 Air cap number, nozzle and needle size combinations.
No. Air cap (2, 3) Nozzle (4) Needle (17)
Order No. Size Order No. Order No.
90 CV-39-90 1.0 mm CV-30-F-K AGF-404-F-K
92 CV-439-92 1.8 mm CV-30-E-K AGF-404-E-K
Figure 2
Figure 3
IMPORTANT: To ensure that this equipment reaches you in first class condition, protective coatings, rust inhibitors etc., have
been used. Flush all equipment through with a suitable solvent before use to remove these agents from the material passages.
Note: A single hose supplies both atomising and cylinder air. To prevent unatomised coating material being expelled from the
nozzle at the end of the spray cycle, all air should be exhausted through the gun. It is recommended that a two-way
valve should be fitted in the control line. If a three-way valve is used, install a plug in the exhaust port.
1. Mount gun on a 9.5 mm ( 3 /
8
") rod or stud (32) and secure with screw (31). A universal clamp is available see accessories, for
use with stud (32) to attach the gun to a 19 mm ( 3 /
4
") rod.
2. Connect air and coating material supplies to connectors (30) indicated by markings “AIR” and “FLUID” on the gun body.
Note: Use a filtered regulated air supply. The minimum air supply pressure required to operate the cylinder is 4 bar (60 lbf/in
2
).
Recommended hose sizes:
Air supply Coating material supply
Length up to 5 m long 6 mm ( 1 /
4
") bore. 6 mm ( 1 /
4
") bore.
10 m long 8 mm ( 5 /
16
") bore. 8 mm ( 5 /
16
") bore.
INSTALLATION