E-4
6. Secure the paper feeder units together in the
rear. (Two supplied screws A)
7. Connect the ground wire of the lower paper
feeder unit to the upper paper feeder unit.
(One supplied screw B)
8. Plug the connector of lower one paper feeder unit
into that of another.
9. Attach the rear cover removed in the step 3.
(One screw)
10. Seeing the steps described in <Installation to the
machine> on page E-2, attach the paper feeder
units to the machine.
III. Loading the paper feeder unit with
paper
1. Slide out the drawer of the lower paper feeder
unit and press down the paper lifting plate until it
locks in position.
2. Load the paper.
Note:
Do not load so much paper that the top of the
stack is higher than the
▼
mark and the separator
fingers.
3. Slide the guide plate and trailing edge stop so
that they are pressed tightly up against the edges
of the paper stack.
A3PFIXC015DA
A3PFIXC016DA
Connector
Ground wire
A3PFIXC007DA
A3PFIXC017DA
A3PFIXC018DA
