In order to derive timing information from the 19kHz stereo pilot, the rear-panel PILOT OR MPX
INPUT connector monitors the output of the stereo generator. When sidechain operation mode is chosen
the RDS OR MPX OUTPUT contains only the RDS sub carrier, the composite MPX signal is not routed
through SmartGen 6.0. This operating mode preserves the multiplex signal integrity and assures
uninterrupted program transmission, in case of encoder failure event. Originally SmartGen 6.0 is
configured for sidechain operation.
1. Connect a BNC 'T' adapter to the
composite/MPX output of the
stereo generator;
2. Using a suitable cable, connect one
side of the 'T' adapter directly to the
wideband (composite/ MPX) input
of the FM exciter;
3. Using a suitable cable, connect the
other side of the 'T' adapter to the
P I L O T O R M P X I N P U T o f
SmartGen 6.0;
4. Cable the RDS OR MPX OUTPUT
of the encoder to the second
wideband (subcarrier) input of the
FM exciter.
Please have in mind
that in the event
of power failure, the pilot tone will
appear on the RDS OR MPX
OUTPUT and will be summarized in
the FM exciter, because of the
incorporated failsafe bypass relay.
This case scenario is unacceptable,
and in order to be prevented, it is
recommended the RDS OUT to be
used in this configuration.
This Quick user guide will make the installation of
the RDS/RBDS Encoder SmartGen 6.0
quick and
easy.
Applying
these principles, you can simplify the process and save yourself extra time and effort.
For
more information about the Safety precautions and the Operating environment recommendations
please refer to the
complete
User Manual.
1.
Install the unit on its operation place;
2.
Before connecting the AC Power, make
sure
that the mains supply at your location
matches
SmartGen
6.0
Power Supply Factory Settings
. The unit can operate within the range of 100 - 240 VAC, 1 Amp
Fuse
;
3. Configure the desired operating mode - sidechain or loop-through before the device is installed in the
signal path
(
For more information refer to
Step
2
&
Step 3
);
4. Before connecting SmartGen 6.0 to other air-chain equipment, u
s
e
the WEB Interface, SmartGen
Encoders Manager or the Front panel navigational menu to confirm that the encoder is properly
configured;
5. In order to program the 'static' message registers and operating defaults, use the operating software or
access the device via the WEB Interface. All settings should be applied before connecting the device to
the air chain.
NOTE:
We recommend testing the encoder with the controlling interface (computer, terminal, automation,
etc.) before SmartGen 6.0 joins the air chain. This will confirm
whether
the encoder is properly
initialized and two-way communication can be established.
NOTE:
The usage of the Sidechain operating mode is recommended.
Connection
STEP 1
Sidechain operating mode
STEP 2
1
"Sidechain" Encoder Connection
FM STEREO GENERATOR
MPX OUTPUT
SmartGen 6
1
2
3
WIDEBAND INPUTS
FM EXCITER / TRANSMITTER
PILOT
/
MPX
IN
RDS
&
MPX
OUT
RDS
OUT
LAN
GPS
GPIO
COM1
COM2
3
4
2
