Deutz EMS2, Описание системы

Страница: 15 / 42

© 0702
Page 67
EMS 2
Inputs/Outputs
5 Inputs/Outputs
5.1 Inputs
The following table provides an overview of the possible outputs at the EMS 2.
An example of pin assignment (engine 1015, EMS and MVS) is shown in Chapter 11.8.
The EMS 2 control unit can be configured in the factory in such a manner that further input signals can be
read via the CAN bus.
No. Pin GND Designation can be connected measured Especially suitable for
1A 1
Speed input
1
1
Speed input available as an option only.
W terminal Frequency For speed measurement only.
1B 10, 27 Pick-up
2 25 29 Limp-home and
diagnosis Sensor to ground Voltages 0 and 5
V (digital) For error code enquiry and limp-
home only.
3 8 PWM input PWM signal switch Pulse-duty fac-
tor (digital) Integration of a physical variable
from another control unit (e.g. oil
pressure).
4 15 13 Pressure mea-
surement input Voltage sensor Voltages 0 to 5 V
(analogue) Oil pressure measurement
5 14 31 NTC input NTC (temperature-
dependent resistor) Resistors (ana-
logue) Coolant temperature
Oil temperature
6 32 30 PT100-1 PT100 (temperature-
dependent resistor) Resistors (ana-
logue) Cylinder head temperature
7 17 PT100-2
8 16 Analogue 1 Voltage sensor Voltages 0 to
U
Batt
(analogue)
Suitable for many signals, e.g.
air filter differential pressure,
fluid levels, etc.
9 34 Analogue 2
10 33 12 Analogue 3 Voltage sensor Voltages 0 to 5 V
(analogue) Suitable for many signals, e.g.
pressures, temperatures, fluid
levels, etc.