Please blanket on mattress with the mains lead at the pillow end. Ensure the controller emerges from the top
side of the blanket and that heating elements do not emerge under the pillow area.
The four clasps on the corners should be fixed tightly to the mattress or the bed after you lay the electric
heating blanket to prevent the blanket from moving or creasing. (The creased part tends to cause high
temperature which is very dangerous.)
USING THE BLANKET
Connect the controller to the blanket (The blanket has a socket attached that the controller slots into) and
ensure it is fully connected.
Ensure there is a mains supply is nearby and that when in use, the mains lead will not be in a position that
could cause people to trip over it. When plugged into the mains supply, the controller must be within easy
reach of the user.
For controller: TWK-1/T4B
Please set preheating at the highest tap
‘3’ position 30-60 minutes before using. When using, select
the appropriate tap position
‘1-2-3’ according to human body’s feeling. If you will go to sleep or use it
for a long time, please set at
“1” tap position which is the lowest position so as to avoid overheating
which may cause human body
’s discomfort.
After use
When the blanket is not in use, please switch the controller to the off position; remove the plug from the
power socket. If the blanket is not to be used for a long period of time, store the blanket in a cool and dry
place.
CLEANING & MAINTAINANCE
When not in use and before cleaning the blanket, disconnect it from the mains.
Disconnect the controller/s from the blanket.
Do NOT immerse the controller/s in water or get them wet.
Clean the surface of the cord with neutral detergent if the cord is dirty and wipe it dry with soft cloth.
Do not submerse the controller in water or get it wet at all.
Do not dry clean this blanket as it could damage the heating elements.
Do not use industrial solvents such as benzene, kerosene or similar solvents to clean it.
Machine washing of the blanket is possible; however, hand wiping it down will prolong the life of the blanket.
To machine wash, remove the controller/s and place the blanket in a net bag and seal it. Use a small amount
of detergent and set the washing machine to a
“Delicate Wash” with a maximum temperature of 40°. When
washed, remove the blanket from the net bag and drape it over a clothes line to dry. Do not use clothes pegs
to secure it.
Do NOT wring out the blanket
Do NOT dry using a tumble dryer
Do NOT iron the blanket
Do NOT dry the blanket in the sun.
Do NOT connect it to the mains supply to dry it
Do NOT use an appliance such as a hair dryer to dry it
Allow the blanket to dry naturally.
Do NOT use the blanket if it is damp or wet.
Do not try to repair the blanket if faulty
– have it looked at by a qualified person.
Examine the blanket frequently to check that there are no signs of wear or damage. If any damage/wear is
spotted, do not use the blanket and seek specialist advice.
If the mains lead or controller is damaged, do not open or attempt to repair them as they must be serviced by
a qualified person.
STORAGE
When not in use, allow it to cool down before folding, then gently fold the blanket and place back into the
packing bag it arrived in.
Make sure the blanket is dry before folding and packing it away. The blanket should be hung in a ventilated
location to dry naturally.
Do not use mothproofing agents on the blanket.
Insulation of the blanket will be damaged if the blanket is dried under the sun, ironed or when mothproofing
agents are used. Damage on the insulation material will cause safety problem.
