GAVIN-6C Instruction Manual
- 43 -
Values:
ON
: If one of the above channels is set to
ON
, it means this channel is to be
used for trainer instruction.
OFF
: If one of the above channels is set to
OFF
, it means this channel is
not to be used for trainer instruction, only the instructor side operates.
The default values for each channel are
ON
,
ON
,
ON
,
ON
,
OFF
, and
OFF
.
3. Start a dual control flight between instructor and student.
During flight, push and hold
TRAINER
switch on the instructor transmitter, the
model will be controlled by signals from the student transmitter. When the
student operates erroneously, the instructor can release
TRAINER
switch and
the instructor transmitter regains control of the model. Then the instructor can
operate the sticks to correct the flight.
CAUTION
: After finishing the trainer operation, please set the value of
Trainer SW
to
OFF
on both the instructor and student transmitters.
Fail Safe [Fail Safe]
If there is signal interference to the transmitter, or the receiver does not receive a
valid RF signal from the transmitter, this function moves the servos to predefined
positions, to avoid a crash.
WARNING:
For safety, always set the fail safe function before each flying session.
Especially set the throttle channel fail safe function, set an appropriate value
for the throttle channel according to the model type.
Remember to implement the fail safe setting after completing the aircraft
settings.
Setting Method:
1. In the
Model Set
menu, press
UP
or
DOWN
key to select
Fail Safe
, and then
press
ENT
key to enter the setting interface.
