Detecto VET330WH, Руководство пользователя

Страница: 10 / 20

1961-M045-O1 Rev B
y
VET-330WH Owner’s Manual
4
SETUP AND INSTALLATION, CONT.
Placing the Display
The VET-330WH display has a 7.0 ft (2.1 m) cable to allow it to be placed at a convenient
position away from the scale base. The included bracket can be used to mount the display
on a wall or it can be used to place it on a desk or table for easy viewing.
Wall Mounting
1. Choose the location to mount the display on the wall where it can be easily viewed, not
subject to direct sunlight, and where the keypad is within easy reach of the operator.
2. Using the bracket for a template, place the bracket against the wall and mark the holes
to mount it. Remove the bracket and drill two (2) 13/64 in (5 mm) holes in the wall for the
mounting wall anchors.
Use the mounting bracket as a template to mark holes to drill.
3. Insert the wall anchors in the wall until they are flush with
the wall.
4. Insert the two (2) M3.0x25 screws into the wall anchors,
and then tighten them until there is approximately 1/8”
(3 mm) gap between the screw head and the anchor.
5. Place the display in the bracket and install the included enclosure knobs. Adjust the
angle of the display for the best viewing, and then completely tighten the knobs.
Place the display in the mounting
bracket and install the enclosure knobs. Adjust display for viewing
angle and completely
tighten enclosure knobs.
6. Place the large end of the slotted holes in the bracket over the screw heads, and gently
pull down to secure the bracket and display to the wall.
Leave 1/8” (3 mm) gap between
screw head and wall anchor.