1. Put 2 screws in the hanger bracket. Leaving them partially out. (Fig. 9.1).
2. Remove three of the six screws and lock washers (every other one) from the top
housing (Fig. 9.2)
3. Place the ceiling canopy over the collar on the top of the motor housing. Align the
mounting holes with the holes in the motor and fasten, using the three screws and
lock washers which are removed in Step 2 (Fig. 9.3)
4. Move the fan assembly up and connect the wires from fan to the wires from ceiling.
(Fig. 9.4)
5. Make wire connections (refer to section titled” ELECTRICAL CONNECTIONS”) For
cUL-listed fan, please secure the safety cable to the junction box.
6. Place the canopy up on the hanger bracket by inserting the slotted opening of the
canopy on the screws. (Fig.9.5)
7. Insert the remaining screws through the remaining canopy holes and tighten all 4
screws.
HUGGER STYLE
Page 8
Screw and
Lockwasher
(3 of 6 places)
Screws
Mounting bracket
Fig.9.1
Fig.9.2
Screw and
Lockwasher
(last 3 places)
Upper
Canopy
Fig.9.3
Fig.9.4
Slotted Hole
