5.
If the above does not eliminate the wobble, clip a balancing kit on any one of
blade about the middle of blade edge. Let fan run. If it is still wobbling, stop the
fan, and change the location. Repeating this procedure on the remaining blades
until the wobble is removed.
6.
You can also look up at the fan from below, make sure that none of the blade
holders are bent so that a blade is out of position. Correction may be made by
GENTLY bending the blade holder back into position.
7.
Blade tracking may be checked simply by use of a household yardstick as
shown in below Figure. Place the yardstick vertically against the ceiling and even
with the outside leading edge of a blade. Note the distance of the edge of a
blade same as others. Turn the blade slowly by hand to check the remaining
blades. If a blade us in an alignment, the blade holder may be gently bent up or
down to be in line with the other blades.
Page 16
FOR 5 BLADES MODELS
FOR 4 BLADES MODELS
Numbered tape
placement
Numbered tape
placement
Switch 1-2
Switch 3-4
Switch 2-1
Switch 2-4
Switch 4-3
Switch 2-1
Switch 3-4
Switch 2-1
Switch 2-4
Switch 4-3
YARDSTICK
MEASURING
POINT