8
Figure 17
Figure 16
11. INSTALLING THE
LIGHT BULBS & GLASS
SHADE
1. Install 2 x 60w candelabra bulbs (not
included). (Fig. 17)
2. Remove the rubber washer, metal nut
and decorative nut from the light kit.
Place glass shade over the light kit
stem, secure with the metal nut and
decorative nut. Do not overtighten.
(Fig. 17)
3. Restore power and your light kit is
ready for operation.
10. INSTALLING THE
LIGHT KIT
NOTE: B e f o r e s t a r t i n g i n s t a l l a t i o n ,
disconnect the power by turning off
the circuit breaker or removing the
fuse at fuse box. Turning power off
using the fan switch is not sufficient to
prevent electric shock.
1. While holding the light kit assembly
under your fan, snap together the
wire connection plugs. (Fig. 16)
2. Carefully push all wires back into the
switch housing, then install the light
k i t a s s e m b l y o n t o t h e s w i t c h
housing with 3 screws provided. Be
sure to tighten all screws. (Fig. 16)
Switch housing
Connection plugs
Light kit
assembly
Screws
Bulbs
Light kit
Glass shade
Decorative nut
Metal nut