7
8. ATTACHING THE FAN
BLADES
Caution: Remove 5 rubber packing
mounts and discard before installation.
Step 1 Attach the blade to the blade
bracket using the screws and fiber
washers as shown in Figure 14. Start screw
into bracket. Repeat for the two remaining
screws.
Step 2 Tighten each screw. Make sure the
blade is straight.
Step 3 Fasten blade assembly to motor
using the screws supplied. (Fig. 14)
Figure 14
Figure 15
Screws
Screws
Fiber
washers
Blade bracket
Blade
9. INSTALLING THE
SWITCH HOUSING
Step 1. Remove 1 of the 3 screws from
the mounting ring and loosen the other
2 screws. (Do not remove)
S t e p 2 . W h i l e h o l d i n g t h e s w i t c h
housing under your fan, snap together
the wire connection plugs .
Step 3. Place the key holes on the
s w i t c h h o u s i n g o v e r t h e 2 s c r e w s
previously loosened from the mounting
ring, turn switch housing until it locks in
place at the narrow section of the key
h o l e s . S e c u r e b y t i g h t e n i n g t h e 2
screws previously loosened and the one
previously. (Fig. 15)
Screws
Switch
housing
Mounting ring
Connector
plug
