Bx9
Now decide if you would like to put the exterior opening of your Designer Catbox on the
right or the left side. If you would like to put the exterior opening on the left side, follow
step
3L
. If you would like to put the exterior opening on the right side, follow step
3R
.
The top piece and the bottom piece
look similar. The bottom piece has
holes close to the edge on EACH
side of the bottom. The top piece
only has holes on THREE of the four
sides. When installing the edging
onto the top piece, ensure that the
wood block on the top piece is
facing down. Screw in B carefully -
Do not overtighten.
Select the side piece with the outer opening.
The piece with the outer opening has a
frame around the opening. Position the back
piece so that the wood square is on the
inside top side. Install piece with the outer
opening with the rounded edge up.
Select the side piece that has a frame, but
no opening. Position back piece so that the
wood square is on the inside top side.
Install the side piece up. The bottom of the
side piece has a hole in the middle.
3L
3R
1
3L
3R
3L and 3R
Start by screwing two posts into the back piece.
Slide side piece over the posts. Push locking piece
into the hole on outside piece. Make sure that the
locking hooks are open so that after it is pushed
into the hole, you can twist it clockwise and the
locking hooks will lock around the posts. Do not
overtighten!
Now continue to steps 4L or 4R on the next page.
Instructions for Setup
Please follow these instructions carefully. For setup, you will need a Phillip’s head screwdriver.
Lx1
(already installed
in interior panel)
