Cruiser AT/RT 604
12
Remote Control
Remote transmitter operates with a battery (provided). The remote range is about 50 meters.
This range may vary depending on the terrain conditions, interferences by other sources and
the power level of the battery in the remote. Remote control provides
14 speed
levels
.
Speed can be increased or decreased by pressing the (+) or (-) buttons continuously.
Attention
: Avoid braking on high speed as this may cause damage on buggy. Try slowing
down first by pressing the (-) button and then brake.
Remote Transmitter Controls
Control buttons & LEDs on Controller
Remote
Operation
The remote operation is very straight forward.
You just need to switch
on the buggy to STAND-BY MODE by turning the speed control knob.
Then just press the remote buttons.
The buggy can easily be controlled
to all directions by this remote device. (Only reverse operation needs more
care and practise because of the swivel front wheel)
Electronic
Bias
Alignment
Motor speeds never can be the same. There may be a difference of
between 5% more or less between the motors. Different motor speeds will
cause a bias and the buggy will not go straight. The motor speeds can be
electronically aligned by a button on the controller. The power to the right
hand side motor can be adjusted and made the same with the left hand
side motor. This should be done while the golf bag is loaded on the buggy.
Remote
Signal LED
There is a LED light both on remote transmitter and controller. They blinks
simultaneously each time you send a signal by the remote transmitter.
Remote
Code
Learning
If you need to use a new remote transmitter for your buggy (lost or
damaged), you need to program the new remote transmitter. 1) Start the
buggy by turning the speed control knob. 2) Press the Remote Control
Learning Button on the controller. 3) Press any of the buttons on the
remote transmitter. The Remote Signal LED will be on for 5 seconds then
will be off. 4) Now the remote transmitter has learned the code.
