Cruiser AT/RT 604
11
User controls
Manual Controls
Manual controls are positioned on the T-shape handlebar.
The speed is set by a speed
control knob at the side of the operation board. This can be set to adjust the speed of the
trolley from about 0kph to p to 10kph (depends on the model). The actual speed of the trolley
will depend on the speed setting and the terrain.
Handlebar Controls
Timer / Electronic Distance Function
On/Off Switch
Stand-by Mode
The buggy will power on at standby mode when the speed roller is
switched on.
LED-2 will be GREEN
indicating that the unit is ON
but the buggy will not start at this time. This is the stand-by mode.
Start/Stop
(LED1)
START
: When the Start/Stop button is pressed
buggy will start
at the set speed of the speed control knob.
LED-1 will be
GREEN.
And the
LED-2 will be on
again but will change its
colour depending on the battery power status.
STOP
: When the Start/Stop button is pressed again the buggy will
stop.
LED-1 will turn to RED
and Led-2 will remain the same.
Battery Level LED
(LED-2)
LED-2
. When the battery capacity falls lower than 90% the LED
will turn ORANGE. The LED will turn RED when the battery is at
10%, warning you to charge the battery soon.
Timer / Electronic
Distance Function
(LED-3)
Press the Electronic Distance Function button; Timer LED will
blink for 5 seconds and your buggy will proceed at the selected
speed for the distance (15/30/45M). Pressing the button once will
turn the
LED-3 GREEN
– indicating that the unit will travel for 15m
at the set speed. Pressing the button again will turn the
LED-3
RED
– indicating that the unit will travel 30m. A third press of the
button will turn the
LED-3 ORANGE
– indicating that the unit will
travel 45m.
