www.desatech.com
121558-01A
2
Figure 3 - Installing Header
Top
Leg
Assemblies
1
1
/
4
" Screw
Figure 5 - attaching top to Leg and Header assembly
Left Leg
Assembly
Right Leg
Assembly
Header
Shoulder
Figure 2 - attaching Front Leg
Figure 4 - attaching Header to Leg assembly
Header Assembly
Block #8
Header
Leg
Assembly
1
1
/
4
" Screw
AttAChing tOP OF mAntel
1. Place mantel top (#7) onto upright leg assembly (see
Figure 5). Align back of top with back of sides.
2. Using six
1
1
⁄
4
" screws with washers, attach top to header/
leg assembly (see Figure 5).
Brackets
Right Side
Figure 1 - attaching Brackets to Side
1. Lay right side panel (#2) face down on a soft surface
to avoid marking finish. Attach four brackets with 1/2"
screws to bottom of right front leg (#3) leaving screws
slightly loose. Face brackets out (see Figure 1). Place
right front leg (#3) over right side (#2) as shown in Figure
2, paying close attention to direction arrow pointing up
on panels. Align threaded holes with brackets on side.
Start four 1/2" screws through brackets. Align bottom of
side and leg assembly so they are flush with each other.
Hold these pieces securely in alignment while tightening
(but not over tightening) screws.
2. Assemble left side (#4) and left leg (#5) as described in
step 1.
3. You may prefer to lay mantel face down on a soft surface
instead of upright to position header. Position header (#6)
between leg assemblies with direction arrow pointing up
(see Figure 3). Attach header assembly blocks (#8) with
1
1
/
4
" screws and washers (see Figure 4).
1/2" Screws
Right Side
Right Front Leg
1/2" Screws
Washer
Washer
Back of Top
Flush with
Back of Leg
Assembly
