www.desatech.com
113135-01A
11
INSTALLATION
Continued
Figure 10 - Installing Cabinet Mantel
Cabinet
Mantel
Figure 11 - Location of Nailing Flanges
Nailing
Flanges
9. If blower is installed, route blower electrical
cord through access holes in either side of fire-
place.
Note:
Bushing may be moved if neces-
sary. Plug electrical cord into electrical outlet.
10. Carefully insert fireplace into cabinet mantel
(Figure 12). Be careful not to scratch or dam-
age hearth base, cabinet mantel, or any lami-
nate trim on hearth base. Remove protective
material from top of hearth base and from front
of fireplace (if any).
Note:
You can secure fire-
place to hearth or floor. Open lower louver.
Locate screw holes in bottom of base. Tighten
wood screws through these holes and into
hearth or floor.
11. Attach gas line from fireplace gas regulator
to gas supply. See
Connecting Fireplace to
Gas Supply,
page 14.
12. Check all gas connections for leaks. See
Checking Gas Connections,
page 15.
Figure 12 - Inserting Fireplace Into
Cabinet Mantel
;;;;;
;;;;;
QQQQQ
QQQQQ
;;;
;;;
;;;
;;;
;;;
QQQ
QQQ
QQQ
QQQ
QQQ
BUILT-IN FIREPLACE INSTALLATION
Built-in installation of this fireplace involves in-
stalling fireplace into a framed-in enclosure. This
makes the front of fireplace flush with wall. If in-
stalling a mantel above the fireplace, you must
follow the clearances shown in Figure 16, page
12. Follow the instructions below to install the fire-
place in this manner.
1. Frame in rough opening. Use dimensions
shown in Figure 13 for the rough opening.
If installing in a corner, use dimensions shown
in Figure 14 for the rough opening. The height is
33" which is the same as the wall opening above.
Actual
Framing
Height
32
3
/
8
"
33"
Front Width
34
5
/
16
"
35
1
/
2
"
Depth
16
11
/
16
"
17
3
/
4
"
Figure 14 - Rough Opening for Installing
in Corner
Figure 13 - Rough Opening for Installing
in Wall
39
3
/
8
"
27
7
/
8
"
55
5
/
8
"
35
1
/
2
"
35
1
/
2
"
17
3
/
4
"
33"
