www.desatech.com
113195-01A
18
INSTALLATION
Continued
OPTIONAL WIRELESS HAND-HELD
REMOTE CONTROL ACCESSORIES
(GHRCB and GHRCTB)
Installing Remote Receiver Unit
1. Disconnect switch wires from the control
valve.
2. Remove screws attaching switch plate.
3. Remove switch plate (see Figure 26). Discard
after removing.
4. Install remote receiver unit onto gas log heater
base using mounting clips.
5. Push clips firmly into place (see Figure 27).
6. Connect wires as shown in Figure 28.
Figure 26 - Switch Plate and Wiring
Harness
Screw
Switch
Plate
Wires
Remote Switch
Bracket
Ignitor
Figure 27 - Installing Remote Receiver
Figure 28 - Connecting Wires
Red Wire
From Receiver
Valve
White Wire
From
Receiver
Remote
Receiver
Mounting
Clips
INSTALLING 9-VOLT BATTERIES
Two 9-volt batteries (not included) are required to
operate this heater with the wireless hand-held
remote control set. Install one battery in the re-
ceiver and one in the hand-held remote control
unit. Note: Only use alkaline batteries.
Installing 9-Volt Battery (Not Included) in
Receiver
1. Locate back of receiver under front burner of
heater.
2. Locate the battery clip mounted on the back
of the receiver.
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
Figure 29 - Installing Battery in Remote
Receiver
Battery
Clip
9-Volt Battery
Terminal
Wires
Remote
Receiver
Figure 30 - Installing Battery in Hand-Held
Remote Control Unit (GHRCB Series)
Battery Cover
9-Volt Battery
Terminal
Wires
Remote
Control Unit
Battery
Housing
Figure 31 - Installing Battery in Hand-Held
Remote Control Unit (GHRCTB Series)
9-Volt
Battery
Remote
Control
Unit
Battery
Cover
Terminal
Wires
