DERMAVIT Diamond Shield IE Crystal, Инструкция по эксплуатации

Страница: 47 / 60

Diamond Shield IE Crystal
Instruction Manual
page 47
„Standard“ menu
Under the menu item Standard you will find the pre-
installed frequency applications, with which the Diamond
Shield IE Crystal Zapper is supplied by default.
Most of these applications consist of a sequence of seve-
ral sub-programs. The first level of the menu shows the
available sequences. When a sequence is selected and
then the
OK button is pressed, the frequency programs of
the selected sequence are shown.
Executing an entire sequence
Select the desired sequence with the + and - button.
To run the entire sequence press the START button.
First the device will test the electrical contact (see the
chapter „Contact control“). Then all the sub-programs of
the selected sequence are successively executed.
Running a single program of a sequence
Select the desired sequence with the + and - button.
Press the OK -button to enter the submenu, where the sin-
gle frequency programs of this sequence are displayed.
Then select the desired single program and run it by pres-
sing the
START -button. Previously the device checks the
electrical contact (see Contact control , page 48).