Deprag 345-300-31L, Руководство по эксплуатации

Страница: 13 / 36

13
Picture: Exchange of clutch spring
Make sure to screw adjustment (adjusting) nut onto clutch bearing
until one line of the thread is visible.
4.2. Torque Adjustment
1. Disconnect driver from air-supply.
2. Unscrew spring sleeve (Optional Equipment) (left hand thread).
3. Unscrew clutch bearing (left hand thread).
4. Take out clutch complete.
5. Put wrench 805492 (AF 6) onto the hex of the clutch shaft and turn
adjustment nut 323711 by means of the wrench 805491 (AF 11). You get
a higher torque by turning the adjustment nut in clockwise (+) order and
vice versa (-) a lower torque.
6. Introduce clutch complete into the clutch bearing and screw the latter on
to the screwdriver.
The hex of the clutch shaft must engage with the hex of the
gear support or spindle (located in gearing).
Check this and ensure that engagement lift on the spindle is
available (only push-to-start-screwdriver).
clutch spring adjustment nut
lock ring
hex of the
clutch shaft