Depaepe Telecom Process, Руководство пользователя, Страница: 33 / 33

33
2. Then press INT key once, you will be prompted to select the number of the internal handset with which
you wish to connect, press the registered sequence number of the handset you want to call
3. The destination handset will ring.
4. Press or key to accept call.
5. Press the key of the initial handset, then you can talk all together.
6. Press to quit the three-way conference mode, then other parties can also continue to
communication.
TROUBLE SHOOTING

No signal bar is displayed on the screen

The handset is out of range. Move it closer to the base station

No dialing tone

Check your phone connections

The handset is out of range. Move it closer to the base station

No docking tone

The handset is not placed properly on the base station/ charger

The charging contacts are dirty. Disconnect the power adaptor first and clean the contact with proper
damp cloth.

The handset on the charger does not charge

Make sure the batteries are inserted correctly.

Make sure the handset is placed properly on the base station/ charger

Batteries are defective. Purchase new ones for replace.

No display

Make sure the batteries are charged

Make sure there is power and the phone is connected

The handset no ring

Make sure the handset ring tone is turned on.

Ring volume too low

Check if the ringing volume is set improper, reset it.

Receive only

Check if P/T mode is properly set.

Check if you have set the barring number, if you want dial out this number, reset the barring number.

The base cannot page the handset

Repeat the registration operations to register the base and handset again.

Most of the functions failed

Check if the batteries are strong enough, charge the batteries.

If batteries are OK, remove the battery, unplug the lines and reinstall after 10 minutes.
Note: Due to continuous product development, all features and specifications are subject to change without
prior notice.