Denzel 26915, Руководство пользователя, Страница: 12 / 32

12
ANGLE GRINDER
EN
To prevent dust and grease leakage this machine has a hermetic design. Therefore, the tool can be used for a long
time and you have no need to replace or add grease. After initial commissioning change lubrication every 6
months of operation. To replace the lubricant, contact the service center.
In case of any damage to the power cord turn off the Angle Grinder immediately, carefully, without touching
the places of damage, disconnect it from the mains.
ATTENTION!
The tool uses power cord with mounting type Y: for security it must be replaced by authorized
repair shop personnel.
Possible faults
Fault Probable cause Problem solution
The tool does not turn on.
Broken power cord or mounting
wire, malfunction of power cord
plug.
Call the service center.
Defective switch. Call the service center.
Brush wear. Call the service center.
Circular fire on the collector.
Fault in the armature winding. Call the service center.
Wearout /«hang» of brushes. Call the service center.
Increased noise in the gear.
Wearout / breakage
of the mechanism parts.
Call the service center.
When working smoke or smell
of burning insulation
is generated from the vent.
Interturn closure of armature
or stator windings.
Call the service center.
Malfunction of the electrical part
of the instrument.
Call the service center.
Increased machine vibration.
Wearout / breakage of gears
or bearings.
Call the service center.
Faulty or improperly installed
tooling.
Replace or reinstall a tooling.
RECYCLING
A tool, developed a designated service life, must be recycled according the rules established by environmental
and other laws of the country, where the tool is operated.
TRANSPORTATION
During the transportation direct exposure of precipitation, direct sunlight, heat and shock is not allowed.
Transportation should be carried out only in the original packaging at temperature from - 20 °С to + 40 °С.
STORAGE
During the assigned service life, store the machine in a dry heated room. Recommended storage temperature
is from 0 °C to +40 °C. Store the tool in the original packaging.
Before placing the drill in storage remove the working tool.