Denzel 26901, Руководство пользователя

Страница: 10 / 32

10
ANGLE GRINDER
EN
This power tool can be connected to power outlets that do not have a protective ground, since it has double
insulation (protection class II).
Spindle speed adjustment (for model AG-125-1100)
Depending on the type of tooling used, the type of material being processed and the nature of processing
you can choose the optimal spindle speed of the machine. The selection is made using the controller 5 (pic.
1). The numbers on the regulator ring correspond to the ring positions and do not indicate a specific speed,
expressed in rotations per minute. A higher number corresponds to a higher spindle speed and tooling.
ATTENTION!
The machine is not intended for polishing work.
ATTENTION!
Do not overload the machine operating at reduced speeds. When the engine rotor speed
decreases, the cooling of the machine deteriorates.
Before using you must:
•
inspect and verify its completeness and no external damage;
•
make sure the power switch works correctly;
•
after transportation in winter conditions before turning on, leave at room temperature until complete drying
of water condensate.
Before getting started, you must:
•
set the handles and protective cover in a convenient for work position;
•
check the tightness of the threaded connection of fixing the tooling;
•
turn the spindle with a tooling by hand: his move must be free without jams;
•
try the machine at idle (also after replacing the grinding wheel);
•
make sure that the power switch is in the «off» position, then connect the machine to the mains.
To turn on the machine, it is necessary to turn the switch 4 into the On / 1 position. If necessary, the power switch
4 can be locked in the «on» position, to do this, move the key to the «on» position and click on the front edge
of the key, the protrusion on which will engage with the groove in the housing and the key will be fixed. To turn
off the machine, press the back edge of the key.
Recommendation: Try the switch key lock mechanism before connecting the machine to the mains.
ATTENTION!
The protective cover should always be installed during operation. Always use safety glasses.
While working:
•
after turning on the engine, let the machine develop the set speed of the tooling and only after that you enter
the tooling and the workpiece into contact.
•
always use the machine only for the types of work for which it is intended. When processing wood, use only
the designated tooling, safety of use of which on an angle grinder, no doubt.
ATTENTION!
Never use saw blades designed for circular saws on angle grinders. It is extremely dangerous!