Denyo DN-C-50-4-06, Инструкция по эксплуатации

Страница: 15 / 30

3. Operation
3
‐
1
Controller of Stationary Type Spot Welding Machine
３‐１‐１
Control methods
《
Important
》
Use
「
TB40-P02X(TEACHING BOX)
」
to set condition .For connecting teaching box, unplug
connector from Reset Box and connect it to the teaching box .
「
PHS-1108 SPECIFICATION
」 「
PHS-1108 INSTRUCTION
」 「
RB40-R02A-XXX SPEC./INST.
」
Please refer to
「
TB40-P02X INSTRUCTION
」 （
optional equipment
）
Control method Synchronous phase control by the thyristor for the welding machine
Squeeze time (initial pressure) (SQ)
１～９９
cyc
Weld time (WT)
０～９９
cyc
Hold time (HT)
０～９９
cyc
Off time (OT)
１～９９
cyc
Time control
Up-slope time (US)
０～３０
cyc
Current control
method
Constant current control and voltage compensation control
(Supplementary information)
•
Power is supplied to the controller from the power supply of the welding machine. The controller does
not need any external power.
•
The control range (the minimum current and maximum current) is determined for each set value by the
connected load. Therefore, the limit values vary depending on the load.
•
When 0% of the set current is specified, the machine is subjected to about 30% of the current effective
when 100% is specified.
(15)