E3
To rear camera video out
To reverse gear control switch
To Hand brake switch
0
7
3
4
4
4
5
5
6
6
8
9
. UNIT
. RELEASE CASE
3. DASH BOARD
4. HEX NUT
5. LOCK WASHER
6. PLAIN WASHER
7. CAR BODY
8. REAR SUPPORT STRAP
9. TAPPING SCREW
0. M5 X 5 HEX BOLT
Dashboard
WIRE CONNECTION
IN / OUT CONNECTOR
DVD Audio Out (GRAY) Rear : White (L) Red (R)
Connect this wire to rear seat A/V monitor system to enjoy
DVD movie
Audio Out (Front): White (L) Red (R)
Audio Out (Rear): White (L) Red (R)
Audio Line In : White (L) Red (R)
CONTROL WIRE
Parking (Gray) :
Connect this wire to car hand brake system
Tel mute (Black) :
Connect to mobile phone unit
When receiving calls, audio sound will be muted.
Rear camera (Red) :
Connect to back rear camera
During back gear condition, this wire should be connected to high voltage.
DRIVING WITHOUT VIDEO DISPLAY
Follow the installation below so when the car is in motion, no video will come out from the LCD screen.
Only sound can be heard from speaker.
Note:
- Only sound can be heard when car is in motion.
- Refer and follow your country’s law regarding driving with video.
Caution:
- Do not attempt to install it by yourself if the instruction is not clear to you. Consult you dealer concerning
the installation procedures.
TO SUPPORT THE UNIT
Video Out (Yellow) : Yellow (Plug)
Connect to external A/V system to display
Video In (Black) : Yellow (Plug)
Connect to external Video equipment
Rear camera In (Black) : Blue (Plug)
Connect to rear camera output
Steps:
. Connect the gray wire to the hand brake system.
. Check your hand brake switch and make sure it
is connected to car body chassis and properly
grounded.
