Denver Electronics SEL-65115, Оригинальное руководство

Страница: 18 / 24

18

Avoid riding in narrow places or in places with obstacles, if possible.
 Jumping on and off the Electric scooter will cause damage that is not covered by the
warranty. There is a risk of injury. Injuries and damage due to "trick riding" are not
covered by the warranty.
 Stand on the pedal with one foot, push the other foot back on the ground and start
sliding. The motor can only start after the vehicle speed reaches 3km/h.
13.6
Charging
 Make sure that the Electric scooter, charger, and DC power input of the device are
always dry.

Note: To charge this Electric scooter, use SOLELY the supplied XHK-922-29415
charger with the following output: 29.4 V - 1.5 A.

Using a different charger may cause damage to the device and other potential risks.

Use the mains adapter to plug the DC input of the device into a conventional socket.
 There will be no light on the charger before charging, when connected to e-scooter the
adapter will light red, and charging has started.

The red indicator lights up when properly charged; if this is not the case, please check
the connections.

Now you can stop the charging cycle. Overcharge shortens the battery life.

The charging process takes up to 3 hours. Do not charge the battery for more than 3
hours. After 3 hours, disconnect the charger from the device and the power supply.
Overcharge reduces the battery service life.

The product must not be charged over extended periods.
 Always keep an eye on the device throughout the charging cycle.

Charge the device only at temperatures between 0 °C and +45 °C.

When charging at lower or higher temperatures, there is a risk that the battery
performance will be reduced; therefore, there is a potential risk of injuries and material
damage.

Store and charge the device in an open, dry area away from combustible materials.
 Do not charge the device in direct sunlight or in the vicinity of open flames.

Do not charge the device immediately after use. Allow the device to cool down for an
hour before charging it.

If the device is left to other people, it must be charged partially (20 - 50%), not fully.
 Do not remove the device from its package to fully charge it and then put it back in the
package.

The device is generally partially charged as shipped from the factory. Keep the device
partially charged until it is used.

Allow the Electric scooter to cool down for at least 1 hour before it can be put in the
package.

Do not leave the device exposed to sunlight in a car.
CAUTION