Dentsply Sirona
Instructions for Use Primeprint
5 Commissioning
5.1 Putting the inLab 4 PC into operation
67 45 173 D3691
D3691.201.01.01.02 04.2021
37
5.1.3
Installing the software
NOTE
Initial installation without device
Perform the initial installation of the software without the connected
device.
The software requires the 2.00 firmware version of the license stick.
Update the firmware version if necessary. For additional information,
refer to the "License manager" section in the user manual inLab CAM.
inLab 4-PC or higher is required for the software.
Use the version of the license manager provided with this version to
import licenses from the license certificate provided.
ü
The license stick firmware is available in version 2.00.
ü
The PC is powered up and all programs are terminated.
1.
Insert the DVD in the DVD drive.
Ä
The setup program starts automatically.
2.
If this is not the case, run the
"Setup.exe" file in the root directory of
the DVD.
Ä
The installation wizard opens.
3.
Click the
"OK" button.
4.
In the next dialog, click the
"Next" button.
Ä
The license agreement is shown.
5.
Read through the license agreement carefully.
6.
If you accept the license agreement, then check the
"I accept the
terms in the license agreement" option and subsequently click the
"Next" button.
7.
In the next dialog, click the
"Next" button.
8.
In the next dialog, click the
"Install" button.
Ä
The program continues the installation routine. This may take
several minutes.
9.
Click the
"Finish" button once installation is complete.
Ä
The software is installed.