Dentsply Sirona Multimat Cube, Инструкция по эксплуатации

Страница: 12 / 40

12
4.2 Commissioning (initial configuration)
When commissioning then unit (turning it on for the first time), the initial configuration program
will automatically appear where you can set the first custom operating parameters.
The initial configuration program can also be started at any time from the menu: <Settings> <General>
<Initial configuration …>.
4.2.1 Working with the touch screen
Numerical input:
Delete last entry
Discard entries and return to previous screen
Commit entries and return to previous screen
Navigation:
Selection slide mode:
Swipe to the left or right on the screen until the desired selection
aperes in the centre.
Scroll bar: Scroll the screen up or down:
Use the scroll bar on the right side of the screen or window to move
the screen contents up or down if not all of the screen’s contents can
be displayed at once.
Hold down the scroll bar and drag it up or down.
Touch to proceed with the initial configuration.
Touch to return to the previous screen.
Exiting the initial configuration program prematurely:
Touch <Cancel>. Your changes will not be saved.
Touch <Commit>. Your changes will be saved.
4 Operation
Observe the safety instructions, Section 1.8 “Safety instructions for commissioning”.
4.1 Turning on the unit
Set the toggle switch to position (ON).
When the unit is switched on, the toggle switch
will be lit in green.