Dentsply Sirona CEREC Primemill, Руководство по эксплуатации

Страница: 25 / 70

Dentsply Sirona
Operating Instructions CEREC Primemill 5 Installation and startup
5.4 Commissioning
67 19 681 D3439
D3439.201.01.01.02 09.2019
25
Machining operation Sub-process Processing chamber LED light strip ON/OFF button
Maintenance Action required –
Close door, change
tool White, constant Yellow, constant Green, constant
Longer actions; e.g.
calibration White, constant Progress bars
displayed in blue
and white, fully in
green Green, constant
Shorter actions; e.g.
machine moves to
starting position White, constant White, constant Green, constant
Action completed
successfully White, constant Yellow, constant Green, constant
Unit shuts down Machine moves to
starting position White, constant White, constant Yellow, constant
- Off Off Blue, constant
5.4.5 Using the processing chamber screen
NOTE
Risk of blockage in the cooling circuit
If chips enter into the cooling circuit of the machine, there is a risk that
the cooling circuit will become blocked.
➢ The processing chamber screen is suitable for all restoration and
material types. It is absolutely essential that no chips enter into
the cooling circuit.
IMPORTANT
It is essential that the screen is emptied and washed following each
milled drilling template.
Check the water level in the water tank following each milled drilling
template, as water is absorbed in the material waste.
The screen enables simpler cleaning of processing chambers.
Place the screen at the bottom of the processing chamber. If needed,
you can easily remove and clean the screen.