dentronix DDS 7000, Руководство по эксплуатации

Страница: 26 / 32

26
6) The third menu item is Additional Cooling Time. The display will show the current setting from
0 to 9 minutes. To change the setting toggle the Door Switch once to add one minute, 3 times
to add three minutes, etc. To advance to the next menu, toggle the Cycle Start Switch.
(Indicates no additional minutes are added to the cool down cycle.)
*default setting
(Indicates additional minutes have been added to the cool down cycle.)
This example shows 9 minutes of additional cooling time.
7) The fourth menu item is the Cycle Log Print. To print a cycle log via the COM port, toggle the door
swich. (See section on COM Port).
8) The fifth menu item is the Service Log Print. To print a service log via the COM port, toggle
the door switch. (See section on COM Port).
9). The sixth menu item is Self Test. This feature is to be used if you suspect that the
sterilizer is not working properly. The Self Test will cause each of the systems to operate in
a short period of time to assure that all systems are working. If needed, perform this test with
the door open in order to see and hear the operations.
a). Press the door switch, OR turn the “Stand-by/On” switch to “On” then “Stand-by”
b). All of the displays will light – observe that all lights work.
c). The Door Lock Pin will activate – observe activation
d). The Heat and Circulating Fan will activate for 10 seconds – observe and hear activation
e). The Circulating Fan and Cool Down Fan will run for 10 seconds – hear the fans run
f). A sound will “beep” indicating end of test
If one of these systems does not work, contact the Dentronix Sterilizer Repair Department.
(Indicates Test Mode Enabled)
10) The final menu item is “Done”. To exit the user menu, toggle the Door Switch and to advance to the
first menu again, toggle the Cycle Start Switch.
(Indicates end of user interface menu)