Dentalux DZB 3 A1, Руководство по эксплуатации

Страница: 21 / 24

18 DZB 3 A1
GB
Fitting/removing the brush
head
■ To remove the brush head
1
, turn it clockwise
and then pull it upwards.
■ To fi t the brush head
1
, put it onto the handle
5
in a slightly off set position and then turn it anti-
clockwise until it is in a straight position above
the on/off switch
4
.
To avoid damage to the appliance, always use
original brush heads.
(For replacement brush heads, see the order card)
Brushing teeth
WARNING!
Due to the unaccustomed eff ect of the toothbrush
there may be some initial gum bleeding, which is
normal. Should this continue for more than two
weeks, consult your dentist.
1) Fit the brush head
1
to the handle
5
.
2) Moisten the brush head
1
under running
water.
3) Put a little toothpaste onto the wet brush.
NOTE
To avoid spray, do not switch on the appliance
until it is in your mouth
4) To start the toothbrush, press the on/off
switch
4
.
NOTE
This toothbrush has a 30-second interval timer,
so that all four jaw quadrants can be cleaned
evenly.
5) Divide your mouth into four parts (quadrants):
upper left, upper right, lower left and lower
right.
6) Start in one quadrant:
Start with the brush head
1
on your gums,
and move the brush upwards/downwards from
the gums to the crown of the tooth.
Proceed in this manner on both the inside and
the outside of the tooth. Start again at the
gums for each individual tooth.
Do not forget to brush the back of the rear
molars.
To clean the chewing surfaces, guide the rotating
brush head over the chewing surfaces with a
little pressure.
7) After 30 seconds, the toothbrush stops briefl y,
to signal that you should start cleaning the next
quadrant. Clean each jaw quadrant using the
same technique.
8) After two minutes, the toothbrush briefl y stops
operating 3 times. This informs you that you
have complied with the dental recommenda-
tion of two minutes cleaning.
9) Press the on/off switch
4
to stop the toothbrush.
10) Then take the toothbrush out of your mouth.
11) After use, rinse the brush head
1
thoroughly
under running water.
12) Replace the protective cap
2
on the brush
head
1
.
IB_93451_DZB3A1_LB2.indb 18 IB_93451_DZB3A1_LB2.indb 18 06.09.13 13:30 06.09.13 13:30