Dension DAB+A, Инструкция по установке и эксплуатации

Страница: 2 / 7

2 3
1. INTRODUCTION
DAB+A is a universal DAB receiver solution that offers DAB audio for all
cars. Easy to use with our free mobile application (supports both iOS and
Android) or with our Bluetooth low energy (BLE) remote control (optional
accessory).
Package contents
► DAB+A device
► Power harness
► Power cable with 2-pin Micro-Fit for active antenna with
external power source
► Installation accessories
DAB+A connectors
2. INSTALLATION
Power supply
First of all, you will need to connect the power cable of the DAB+A. In
order to give power to the device, please use the included car side power
cable and connect the 3 power leads as follows:
► Red: +12V Battery (permanent 12V)
► Purple: +12V Switched (ACC or ignition)
► Black: Ground (GND)
Fitting the DAB antenna
► The DAB reception and performance depends on many factors, both on
the vehicle and other external conditions.
► Before you start the antenna installation and/or the product testing,
please make sure that you have a good DAB coverage and reception.
Important notes:
► If your vehicle comes with metalized windscreen (e.g. windscreen
heating) an external antenna is required.
► The DAB module supports both amplified and nonamplified aerials.
For amplified antennas we support phantom power through the SMB
antenna connector and also 12V power is provided by the DAB receiver
via the 2-pin molex connector.
► Read the manual of the antenna carefully and follow the instructions in
order to find the right place for installation.
► Always test (read next chapter) the DAB functions before finalizing the
installation.
Aux-out – 3,5mm Jack auxiliary
output to connect the device to the
head unit through AUX
SMB ANT. – Antenna connector with
phantom power support
Active ANT12V – 12V Power output
for antennas with external power
support
DC in – Connector of the main power
harness
USB Charging – USB connector for
charging smartphones
Status LED – Status LED
Aux-in – 3,5mm Jack auxiliary input
for music playback from external
audio devices
AUX-out
Active
ANT. 12V
DC in USB
Charging
Status
LED
AUX-in
SMB ANT.