24
Operation
TUNING/PRESET
ON/STANDBY
MENU
DIMMER
MENU
DIMMER
CHANNEL
/CONTROL
ENTER
DRC (Dynamic Range Control)
Last function memory
Initialization of the microprocessor
Either turn the
TUNING/PRESET
knob clockwise
or press the
CHANNEL/CONTROL
button.
• The DRC (Dynamic Range Control) function lets you change
the dynamic range of the received sound depending on the
content of the broadcast so that the sound is easier to hear
even when the volume is low.
• The dynamic range can be fine-adjusted in three steps.
• When the indication of the display is not normal or when the
operation of the unit does not shows the reasonable result,
the initializaton of the microprocessor is required by the
following procedure.
DRC OFF
DRC ON
The display changes as follows each time the
TUNING/PRESET
knob is turned clockwise or the
CHANNEL/CONTROL
button is pressed.
DRC OFF: DRC is switched off.
Any DRC level broadcast will be
ignored.This is the default setting.
DRC ON : Applies DRC level as sent with the
broadcast.
This is effective when in a noisy environment and
in quiet sections of broadcast programmes.
The broadcast’s DRC level is set at the broadcast
station.
The DRC can be changed to achieve the optimum level.
1
Press the
MENU
button to select menu.
2
Either turn the
TUNING/PRESET
knob or
press the
CHANNEL/CONTROL
button to
display the DRC value mode selection screen.
3
4
Press the
TUNING/PRESET
knob or
ENTER
button to set the DRC value mode.
1
Unplug the power cord from the power outlet
after pressing the
ON/STANDBY
button and
setting the standby mode.
2
Hold the
DIMMER
button and
MENU
button,
and plug the power cord into the power outlet.
3
Check that the entire display is flashing with
an interval of about 1 second, and release your
fingers from the 2 buttons and the microproce
ssor will be initialized.
• This unit is equipped with a last function memory which
stores the input and output setting conditions as they
were immediately before the power is switched off.
This function eliminates the need to perform complicated
resettings when the power is switch on.
• The unit is also equipped with a back-up memory.
This function provides approximately one week of
memory storage when the main unit’s power switch is
off and with the power cord disconnected.
• If step 3 does not work,start over from step 1.
• If the microprocessor has been reset,all the button settings
are reset to the default values (the values set upon shipment
from the factory).
Downloaded from
www.Manualslib.com
manuals search engine
